Scope of the ASTM B348 Specification
ASTM B348 covers hot-rolled and cold-finished titanium and titanium alloy bars, rods and billets in the annealed condition. The standard defines composition limits, mechanical properties, dimensional tolerances and testing requirements for rounds, squares, hexagons and flats. Grade 4, identified as UNS R50700, is the strongest commercially pure grade in the specification and is widely ordered for aerospace fastener stock and machined components.
Chemical Composition and Mechanical Properties
Grade 4 bar contains up to 0.50 percent iron and 0.40 percent oxygen, with limits of 0.08 percent carbon, 0.05 percent nitrogen and 0.015 percent hydrogen. The elevated oxygen content strengthens the alpha structure, giving a minimum tensile strength of 550 MPa and a minimum yield strength of 480 MPa. This strength approaches the level of some alloyed titanium materials while retaining the simple processing and predictable behavior of a pure grade.
Fastener Production from Grade 4 Bar
Aerospace fasteners such as bolts, nuts, rivets and threaded inserts are machined from bar stock, and Grade 4 is chosen when the design needs a corrosion-resistant fastener with moderate strength. Because Grade 4 has limited cold headability, most fasteners are machined or warm formed rather than cold headed. The bar is normally supplied with tight diameter tolerance and a smooth surface so that machining yields clean threads and controlled fillets without excessive scrap.
Fittings and Structural Components
Beyond fasteners, Grade 4 bar is machined into tube fittings, brackets, clamps, spacer rings and other lightly loaded structural parts. The material's good fatigue behavior in the annealed condition and its immunity to galvanic attack in mixed-metal airframe joints are important advantages. Parts made from Grade 4 weigh roughly 45 percent less than equivalent steel parts, which supports the weight budgets of modern aircraft programs.
Corrosion Performance in Aerospace Environments
Grade 4 resists atmospheric corrosion, aircraft fluids and salt fog through its self-healing titanium dioxide film. The film prevents the pitting and stress corrosion that can affect plated steel fasteners in coastal and high-humidity operations. When Grade 4 fasteners are assembled into aluminum structures, the passive behavior of titanium minimizes galvanic corrosion of the aluminum at the joint.
Procurement and Quality Considerations
Aerospace orders for Grade 4 bar are placed with mill test certificates, heat traceability and, when required, ultrasonic inspection for internal soundness. Chemical analysis confirms the oxygen level, which is the key control on strength and ductility. Dimensional and straightness checks, surface condition review and mechanical testing of representative samples complete the acceptance routine.
Frequently Asked Questions
Q: Why is Grade 4 titanium used for aerospace fasteners?
A: Grade 4 offers the highest strength of the commercially pure grades with full corrosion resistance, light weight and predictable machinability, making it reliable for bolts, nuts and fittings.
Q: What is the strength of Grade 4 titanium bar?
A: Annealed Grade 4 bar provides a minimum tensile strength of 550 MPa and a minimum yield strength of 480 MPa under ASTM B348.
Q: Can Grade 4 titanium fasteners be cold headed?
A: Cold heading of Grade 4 is limited by its oxygen content, so aerospace fasteners are normally machined or warm formed from bar stock to achieve the required geometry.
Q: Does Grade 4 titanium cause galvanic corrosion with aluminum?
A: Titanium is passive in service, so the galvanic couple with aluminum is mild, and the aluminum member remains protected as long as the joint is not driven into an active state.
Q: What testing is standard for aerospace Grade 4 bar?
A: Chemical analysis, tensile testing, ultrasonic inspection when required, dimensional checks and surface examination are the standard acceptance steps.





