Mar 04, 2024 Leave a message

Production Methods for Large-Diameter Titanium Tubing

1. The Challenge of Large Diameters

Large-diameter titanium tubing is generally understood as pipe above the sizes that can be produced economically by the standard seamless route. The diameter is limited by the billet size, the extrusion press capacity and the pilger mill range. Above this limit, welded construction from strip or plate becomes the practical method. The choice between the routes depends on the diameter, wall thickness, quantity and the required quality level.

2. Seamless Production Limits

Seamless titanium pipe is produced by extruding a pierced billet and reducing the hollow by pilgering and drawing. The maximum diameter depends on the press capacity and the size of the extrusion tooling, and large-diameter seamless pipe is heavier and more expensive per metre than welded pipe. Where seamless is still required, for example for high-pressure service or where no weld is acceptable, the size range is extended by special presses and large pilger mills.

3. Longitudinally Welded Pipe

Longitudinally welded pipe is formed from titanium strip or plate that is roll-formed into a cylinder with the edges brought together and welded along the seam. The welding is performed by gas tungsten arc or plasma arc welding under full inert gas shielding, and the weld is cold worked and annealed to restore the properties. After welding, the pipe may be mechanically expanded to set the final diameter and roundness. This route covers a wide range of diameters with good economy.

4. Spiral Welded Pipe

For very large diameters, spiral welding is used, in which the strip is fed at an angle to the pipe axis so that the seam runs in a helix around the pipe. The process produces pipe continuously from a single strip width, which keeps the tooling simple and the cost low for large diameters. The helical seam is welded under the same shielding and inspection discipline as the longitudinal seam, and the weld quality is verified by the same methods.

5. Forming from Plate

The largest diameters are made by bending titanium plate into half-shells and welding them together. The plate is rolled or pressed into cylinders, the longitudinal seams are welded, and the sections are joined circumferentially to reach the required length. This method allows diameters of one metre and above, which are used for process vessels, stacks and large ducting. The forming and welding procedures are qualified and the welds are fully inspected.

6. Quality Control for Large-Diameter Pipe

All welded pipe is examined along the full weld length by ultrasonic or radiographic testing, and the weld surfaces are inspected visually and by penetrant testing. Hydrostatic or pneumatic pressure tests prove the pressure rating, and dimensional checks cover the diameter, ovality, wall thickness and straightness. The pipe is marked with the grade, heat number and lot, and the certificate documents the material and test results. The acceptance level follows the product specification, such as ASTM B862.

Longitudinal welding covers the mid-diameter range economically.

Spiral welding and plate forming handle the largest diameters.

Full-length ultrasonic or radiographic weld examination is applied.

Frequently Asked Questions

Q: What is the largest seamless titanium pipe size?
The limit depends on the extrusion and pilgering equipment, but above a certain diameter welded construction is more economical and more common.

Q: Why is welded pipe used for large diameters?
Welded construction from strip or plate avoids the size limits and high cost of the seamless route for large diameters.

Q: What is the difference between longitudinal and spiral welding?
Longitudinal seams run along the pipe length, while spiral seams run in a helix, which allows continuous production of very large diameters.

Q: How are large-diameter welds inspected?
By ultrasonic or radiographic examination along the full weld length, plus penetrant testing, pressure testing and dimensional checks.

Q: Which standard covers welded titanium pipe?
ASTM B862 covers welded titanium and titanium alloy pipe, and the material follows the appropriate base specification for the grade.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry