1. Physical Properties
Titanium has a density of about 4.51 g/cm³, roughly 60 percent of the density of steel, and a melting point of about 1668 °C. Its elastic modulus is about 110 GPa, roughly half that of steel, which gives titanium components a natural flexibility and a high resistance to fatigue under repeated strain. The coefficient of thermal expansion is low, about 8.6 µm per metre per degree Celsius, which helps in applications where dimensional stability under temperature change matters. The metal is non-magnetic, which is valuable in instruments and medical environments.
2. Mechanical Properties
The strength of titanium spans a wide range depending on the grade. Commercially pure grades offer minimum tensile strengths from about 240 MPa for Grade 1 to 550 MPa for Grade 4, while alloy grades such as Grade 5 reach 895 MPa with good ductility. The strength-to-weight ratio of titanium alloys is among the best of all structural metals, which is why they dominate aerospace structures and engines. The fatigue strength is high, and the material absorbs energy well before fracture.
3. Corrosion Resistance
Titanium forms a thin, stable oxide film that repairs itself when damaged, giving outstanding resistance to seawater, chlorides, oxidizing acids and many chemical media. It does not suffer the pitting and stress corrosion cracking that limit stainless steel in chloride service, and it is immune to microbiological corrosion. The main limitations are hot reducing acids and hydrofluoric acid, and alloying with palladium or molybdenum and nickel extends the resistance into those media. No coatings are needed in most services.
4. Biocompatibility
Titanium is biocompatible: it is accepted by the human body without significant reaction, and the stable oxide film allows bone to bond directly to the surface. This property makes titanium the standard material for dental implants, bone plates, screws and joint replacements. The low density also makes the implants lighter for the patient. Implant grades such as Grade 5 ELI are covered by standards such as ISO 5832-3 and ASTM F136.
5. Functional Uses in Industry
In aerospace, titanium is used for airframes, engine parts, fasteners and hydraulic systems because of its strength, light weight and temperature capability. In chemical plants and power stations, titanium heat exchangers, piping and vessels resist corrosion for decades. In marine service, titanium propeller shafts, seawater systems and deep-sea equipment take advantage of its seawater immunity. The metal also appears in sports equipment, architecture and consumer products where its properties justify the cost.
6. Selecting Titanium for a New Application
Selecting titanium starts with the service requirements: temperature, pressure, fluid chemistry, mechanical loads and expected life. The grade is chosen for the dominant requirement, and the product form follows the specification, whether plate, sheet, bar, tube, pipe, wire or forgings. The cost is balanced against the life-cycle benefits of corrosion resistance and light weight. When the selection is made correctly, titanium components outlast alternative materials and reduce maintenance.
Density is about 4.51 g/cm³, roughly 60 percent of steel.
The self-repairing oxide film provides the corrosion resistance.
Biocompatibility makes titanium the standard implant material.
Frequently Asked Questions
Q: Is titanium stronger than steel?
Not in absolute terms, but titanium alloys have a higher strength-to-weight ratio, so a titanium part can be lighter than steel for the same load.
Q: Does titanium rust?
No, titanium does not form red rust, and its self-repairing oxide film protects it from corrosion in most environments.
Q: Is titanium magnetic?
No, titanium is non-magnetic, which makes it useful in instruments and medical applications where magnetic interference must be avoided.
Q: Can titanium be used in the human body?
Yes, titanium is biocompatible and is widely used for implants, with implant grades covered by standards such as ISO 5832-3.
Q: What is the main disadvantage of titanium?
The cost of the metal and the difficulty of processing are the main disadvantages, which are justified where the properties provide a real benefit.





