Why Titanium Valves
Valves in corrosive service fail at the wetted surfaces, and titanium gives those surfaces an oxide film that resists seawater, chlorides and oxidizing acids. The low density of the metal also lightens the valve and its actuator, which simplifies installation and reduces support loads. Where stainless steel valves corrode within months, titanium valves run for years with the same maintenance schedule.
Valve Components and Materials
The valve body and bonnet are typically cast or forged from GR2 for general service, with GR12 chosen for reducing acids and crevice risk. The stem, ball and seat rings are machined from GR5, Ti-6Al-4V, for strength and galling resistance in the sealing zone. Seats are often overlaid or fitted with polymer or metal inserts matched to the media and temperature.
GR2 for bodies in seawater and chloride service.
GR12 for bodies in reducing-acid and brine duty.
GR5 for stems, balls and high-load trim.
Polymer seats for soft sealing and metal seats for fire-safe design.
Typical Services
Titanium valves dominate chlorine handling, seawater systems, oxidizing-acid service and pulp bleaching lines. They are also used in desalination plants, offshore firewater systems and chemical transfer stations. In each case the valve is chosen because the wetted parts survive the specific media without pitting, crevice corrosion or erosion.
Valve Types
Ball valves with titanium bodies and balls are standard for on-off duty in corrosive lines. Butterfly valves are used in large seawater and firewater systems, check valves protect pumps and compressors, and globe valves control flow in chemical dosing. The titanium components are machined to the same tolerances as steel valves and are interchangeable in standard flanged and threaded patterns.
Standards and Ratings
Titanium valves are built to the same dimensional and rating rules as other metal valves, including ASME B16.34 for pressure-temperature ratings and the applicable face-to-face standards. Body material follows ASTM B367 for castings and B381 for forgings. The rating of the valve is confirmed by shell and seat tests at the factory before shipment.
Selection Guidance
Select GR2 for seawater and oxidizing media, GR12 for reducing-acid and crevice risk, and GR5 for high-pressure and high-cycle duty. Confirm the pressure-temperature rating against the process, and specify the seat and seal materials for the media temperature. The valve certificate records the body material, testing and rating for traceability.
Frequently Asked Questions
Q: Why are titanium valves used in chemical plants?
A: The oxide film resists seawater, chlorides and oxidizing acids, giving valve life that stainless steel cannot match.
Q: Which titanium grade is used for valve bodies?
A: GR2 for general service and GR12 for reducing-acid and crevice-risk duty.
Q: Which grade is used for stems and balls?
A: GR5, Ti-6Al-4V, for its strength and galling resistance in the sealing zone.
Q: What standards govern titanium valves?
A: ASME B16.34 covers ratings, with ASTM B367 for cast bodies and B381 for forged bodies.
Q: Are titanium valves fire-safe?
A: Metal-seated designs meet fire-safe requirements, while soft-seated versions are selected for tight shut-off.
Q: What tests are performed before shipment?
A> Shell and seat pressure tests confirm the rating of every valve before delivery.





