Mar 11, 2024 Leave a message

What should I pay attention to when cutting and machining titanium?

When cutting and machining titanium, the following characteristics of titanium should be noted.

(1) Titanium has a high coefficient of friction, which causes high temperature in the chip during cutting and accelerates tool wear; (2) Titanium has a low thermal conductivity.

(2) The thermal conductivity of titanium is small, the chips are tough and do not curl, and the heat generated by friction with the tip of the tool is almost entirely concentrated on the cutting edge and the forward tilting surface of the tool, which results in burns on the cutting edge. Therefore, the amount of feed should not be too small, and the cutting speed should not be too high, or else it will be easy to stick to the knife and the fine titanium chips will burn, resulting in accidents; (3) Due to the elasticity of titanium, it is easy to generate high temperature during the cutting process.

(3) Due to the small modulus of elasticity of titanium, deep cutting of fine workpieces are prone to deflection, the workpiece is easy to leave the tool, so in the processing of the need to install anti-vibration frame; (4) Titanium has a high temperature activity, so that the cutting edge is burned.

(4) Titanium has high-temperature activity, which may lead to surface contamination of the workpiece during machining.

(5) Because titanium contains high hardness oxides, nitrides and carbides, so in the cutting process is easy to lead to the cutting edge of the tool soon wear; (6) when cutting titanium, the cutting edge of the tool is easy to leave the tool, so it is necessary to install a vibration isolator.

(6) cutting titanium, cutting force is small, cutting processing is not easy to produce cutter marks, so it can be higher surface finish processing.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry