Dec 06, 2023 Leave a message

Optimal Brazing Methods for Titanium and Titanium Alloys

Why Atmosphere Control Is Essential

At brazing temperature, titanium reacts violently with oxygen, nitrogen and hydrogen. The surface oxide film prevents molten filler from wetting the joint, and absorbed gases embrittle the metal. Flux cannot be used because it reacts with titanium itself.

The brazing atmosphere must therefore be a vacuum of better than about 10-4 mbar or a high-purity inert gas such as argon. Under these conditions the oxide dissolves or breaks down and the filler metal can wet the surface.

Vacuum Brazing as the Optimal Method

Vacuum brazing is the preferred method for titanium because the vacuum both protects the surface and promotes deoxidation at temperature. The parts are cleaned, assembled with the filler, and heated in a vacuum furnace to the brazing temperature, typically 850 to 1000 degrees Celsius depending on the filler.

The controlled heating and cooling cycle produces sound joints with minimal distortion, and multiple assemblies can be brazed in one furnace load for repeatable quality.

Filler Metal Selection

Titanium-based filler alloys such as Ti-Zr-Cu-Ni are the first choice because they match the base metal electrochemically and produce joints with high strength and corrosion resistance. Silver-based fillers are used where lower brazing temperature is required, and aluminium-based fillers serve low-temperature assemblies.

The filler must be compatible with the service temperature of the joint. Titanium-based fillers produce joints that serve up to about 400 to 500 degrees Celsius, while silver and aluminium fillers are limited to lower temperatures.

Surface Preparation and Joint Design

Surfaces must be free of grease, oxide and scale before brazing. Standard preparation is degreasing followed by pickling in a hydrofluoric-nitric acid mixture, and the parts must be handled with clean gloves afterwards.

Joint clearance is typically kept between 0.05 and 0.15 millimetres so that capillary action draws the filler completely through the joint. The design must allow filler placement and avoid trapped volumes where gases could collect.

Brazing Cycle and Post-Brazing Treatment

The brazing cycle includes a slow heating stage to allow outgassing, a hold at brazing temperature for the filler to flow, and a controlled cooling stage to limit distortion and residual stress. Temperature uniformity in the furnace load is essential for consistent results.

After brazing, the joints are inspected by visual examination, dimensional checks and, where required, radiography or ultrasonic testing. For critical aerospace joints, a diffusion treatment after brazing can improve joint ductility.

Frequently Asked Questions

Q: Why is flux not used when brazing titanium?

A: Titanium reacts with flux chemicals, so brazing must be done in a vacuum or inert atmosphere instead of with flux.

Q: What is the best brazing method for titanium?

A: Vacuum brazing is the most reliable method because it protects the surface and promotes deoxidation at temperature.

Q: Which filler metal is used for titanium brazing?

A: Titanium-based fillers such as Ti-Zr-Cu-Ni are preferred, with silver-based fillers for lower-temperature service.

Q: What joint clearance is recommended?

A: A clearance of 0.05 to 0.15 millimetres allows capillary action to fill the joint completely.

Q: At what temperature is titanium brazed?

A: Brazing temperature is typically 850 to 1000 degrees Celsius depending on the filler alloy.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry