Mar 12, 2024 Leave a message

Design Of Titanium And Titanium Alloy Turbine Blades

Advantages of titanium and titanium alloy

(1) Titanium improves corrosion resistance and service life. Titanium has good corrosion resistance in seawater and steam, long service life and less maintenance. Superior to other alloys, titanium condenser tube life of up to 20 years.

(2) Good exchange. Titanium's excellent corrosion resistance, but the titanium tube is much thinner than the copper tube. Although the thermal conductivity of titanium is lower than copper. But the heat exchange capacity can be increased by 3% - 5%.

(3) No need for leak-proof ancillary equipment. With the use of titanium condenser tubes, the leakage rate is greatly reduced and lowered, saving treatment and money.

(4) Improve the flow rate of cooling water. Due to the good corrosion resistance of titanium, sediments such as mud and dirt are not easy to adhere to the surface of titanium. It helps to increase the flow rate of water.

(5) Power saving. Since the titanium tube is thinner than the copper tube, when the outer diameter is certain, the inner diameter of the titanium tube is larger, which can save the power of the pump.
The use of titanium condensers improves the operation rate and safety of atomic power stations

Titanium has a high specific strength and good corrosion resistance, lower density than steel, titanium, become compelling steam turbine blade material, because of its high specific strength can improve the unit of low-pressure turbine size of the design ability, the size of the steam turbine by the latter row of blade length is greatly affected, if the last row of blade length growth, it can save energy. Titanium can increase blade length without raising the stresses in the rotor.

In the 1980s, the United States with Ti-6Al-4V instead of the commonly used 12% Cr steel, in the case of not increasing the blade root connection load, can make the last row of blade length growth of 40%. Titanium has excellent corrosion resistance to corrosion-resistant substances in the steam turbine, made of turbine blades used in the environment containing chlorides, hydroxides and salts, there will be no pitting, stress corrosion and corrosion fatigue. U.S. titanium blades have been used for more than 20 years without failure. Now more and more titanium alloys are used in the manufacture of advanced steam turbine blades.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry