Why Plastic Processing Matters for Titanium
Plastic processing, also called plastic deformation processing, converts cast titanium ingots into wrought products such as plate, sheet, bar, tube and wire. Beyond shaping, the deformation refines the cast structure, closes internal porosity and develops the fine grain structure that gives wrought titanium its strength and ductility. The processing route therefore determines both the geometry and the mechanical quality of the final product.
The Hot Working Window
Titanium is normally deformed above its recrystallization temperature to keep flow stress low and avoid cracking. Commercially pure titanium has a beta transus of about 882 degrees Celsius, while alloys such as Grade 5 have a transus near 995 degrees Celsius. Working above the transus in the beta field produces coarse structures, while working below it in the alpha-beta field refines the structure, so the temperature is chosen carefully for each grade and product.
Forging
Forging shapes titanium into billets, bars and complex components using hydraulic presses and hammers. Ingots are first cogged in the beta field to break up the cast structure, then forged in the alpha-beta field to refine grain size. Isothermal forging and die forging produce near-net shapes for aerospace parts, reducing machining cost. Forging temperature, reduction ratio and cooling rate are controlled to hit the target microstructure.
Rolling
Rolling produces plate, sheet and strip from forged slabs. Hot rolling in the alpha-beta field refines the structure, and thin sheet may receive final passes with controlled temperature to control texture and flatness. Rolling direction influences the anisotropy of properties, so the schedule is designed to balance strength in both directions. Modern mills use reversing and tandem stands with tight thickness control.
Extrusion and Drawing
Extrusion pushes heated billets through a die to produce bars, tubes and profiles in one operation, often followed by drawing to improve dimensions and surface finish. Tube drawing through dies over mandrels reduces wall thickness and diameter while improving mechanical properties through cold work. Wire drawing produces fine wire for welding filler and fasteners. Each step may be followed by annealing to restore ductility.
Process Control and Quality
Temperature measurement, deformation monitoring and lubrication control are essential because titanium oxidizes rapidly above about 500 degrees Celsius. Protective coatings and inert atmospheres limit oxygen pickup, and the surface oxide is removed by pickling after hot working. Final products are inspected for surface defects, dimensions and mechanical properties, with microstructural examination confirming that the processing achieved the intended structure.
Frequently Asked Questions
Q: Why is titanium usually hot worked?
A: Hot working lowers the flow stress of titanium and allows large deformations without cracking, while cold working is limited by the material's low ductility.
Q: What is the beta transus of titanium?
A: The beta transus is the temperature above which all alpha phase transforms to beta, about 882 degrees Celsius for pure titanium and near 995 degrees Celsius for Grade 5.
Q: What is the purpose of forging titanium?
A: Forging breaks up the cast structure, refines grain size and shapes the material, developing the strength and ductility required for the component.
Q: How is titanium tube produced by plastic processing?
A: Tube is extruded or pierced from billets, then reduced by cold pilgering or drawing with intermediate annealing to reach final size.
Q: What happens if titanium is heated too long in air?
A: Titanium absorbs oxygen above about 500 degrees Celsius, forming a hard brittle surface layer that must be removed by pickling or machining.





